How to operate the water tank drawing machine? What are the matters needing attention in the operation of the drawing machine?

To provide you with the wire drawing machine safety operation procedures how to operate the wire drawing machine? What are the matters needing attention in the operation of the drawing machine? For your reference:

First, the requirements of posts:

The operator must hold drawing machine operation qualification certificate, wire drawing machine is strictly prohibited without operating personnel.

The operating personnel must be specified in the equipment for production of processing operations, non personnel operating or on the machine operation.

The operating personnel must be familiar with the equipment of the basic technical parameters and performance indicators.

Finally, the operating personnel must be dedicated, responsible, skilled operation, maintenance and maintenance of the equipment.

The operating personnel must constantly sum up learning by itself continuously improve the quality of.

Two, safe operation:

The operating personnel must wear gloves, to prevent the workpiece burn fingers and affect the quality of products.

The boot shall carefully check the gas supply equipment

(5kg/cm2) whether the air supply pipeline is leaking, and the water in the air filter is discharged.

The correct installation of the drawing belt (arrow drawing belt inside the direction of the arrow and the wire drawing roller line). Carefully check the upper and lower bearing seat and the lifting screw lubrication is good, to determine the material on the front when no one can boot.

The device starts immediately after the inspection, the belt swing is within the required range, there is no other abnormal phenomenon, or should immediately adjust or shutdown processing.

It is strictly prohibited, drawing machine and start at the same time fan, do not start after the operator left the job.

It is strictly prohibited without drawing directly on the workpiece pallet on the conveyor belt, wooden pallet without block direct workpiece drawing is prohibited, so as to avoid damage to the conveyor belt and the workpiece flying away.

One, two operations, equipment behind the operator shall not be exported on drawing machine, so as to avoid the workpiece in case of flying away.

Therefore, drawing machine pressure adjustment should be moderate, pressure gauge general instructions should be 35~75, no more than the red line, so as to avoid equipment or accidents.

Only under normal operating conditions, equipment strictly adjust the air pressure, so as to avoid the belt caused by out of control equipment, personal accident.

That, in the course of the equipment running abnormal phenomenon, should be immediately shut down, power outages, so as to avoid the expansion of the fault.

These equipment in maintenance should turn off the power supply, and brand operation is strictly prohibited in order to avoid the accident.

The work, or equipment to use when should turn off the power and compressed air, to ensure the safety of equipment.

Three, operation requirements:

The work should carefully read the drawings and technical documents, so as to avoid batch scrap or waste.

The processing operation should be carefully determined according to the technical requirements of drawing direction, wire drawing, the correct choice of drawing belt.

The processing process should wear gloves, pay attention to the workpiece surface protection, prevent scratches, bruises surface artifacts caused by waste.

It is strictly prohibited without cleaning the workpiece drawing directly.

The work should be finished, gently, and layered protection packaging, so as not to cause surface injury.

6, timely cleaning of waste recycling box, ensure the normal operation of the fan.

Four, equipment warranty:

Giving a monthly equipment (down 4 hours) and maintenance thoroughly.

1, daily maintenance:

First, keep the equipment external cleaning, gas pipeline inspection and quick joint is good.

The upper and lower bearing seat and the lifting screw (lubricating grease gun refueling).

The exhaust air filter in the water.

Finally, check the belt and balance adjustment.

2, Zhou Baoyang:

The removal of daily maintenance leave sludge, daily maintenance requirement of lubrication and maintenance.

The inspection of conveyor belt and tension (such as tension is too loose, please to moderate).

The check and belt tensioning (such as tension is too loose, please to moderate).